Question: How Do I Pass Inspection On My Summer Car?

How do you make a car in a summer car?

Step One: Work on the Front Suspension.

Step 2: Work on the Rear Suspension.

Step 3: Put Together the Engine.

Step 4: Install the Engine.

Step 5: Work On Everything Under the Hood.

Step 6: Build Out the Car Interior.

Step 7: Work on the Car Exterior.

Step 8: Adjust Your Wheels.More items…•.

Where is Grandma my summer car?

Grandmother Sirkka lives in her house, some distance from the player’s farm.

How accurate is my summer car?

In short, My Summer Car is more or less an accurate depiction of a typical teenage Finnish summer back in the day. Note: While there’s no story yet, this is one of those games that are best played blind, so some listed tropes might spoil the surprise.

How do you relieve stress in a summer car?

Stress. The player character’s stress level can be lowered by drinking alcohol, chopping firewood, winning the rally, passing the car inspection, swearing, using a sauna, smoking cigarettes, drinking coffee, eating cooked meats, or being on the island.

How do you pick up a wrench in a summer car?

The spanner set can be opened by looking at the side that has the handle and pressing F . Tools can be picked up from the opened spanner set by first pressing 2 to enter tool mode, and then pressing LMB on the desired tool.

Where does the inspection cover go in my summer car?

The inspection cover is placed on the gearbox. It enables the player to inspect the clutch without taking the engine out. It is bolted to the gearbox using 4x7mm bolts and cannot be painted.

How do you adjust a distributor in a summer car?

The distributor is an easily missable opportunity to tune your car’s performance. Tuning distributor adjusts ignition timing, advancing or retarding it. To adjust, loosen distributor hold-down screw with flat-head screwdriver and, using the scroll wheel in hand mode, rotate distributor clockwise or counterclockwise.

Where do you put a fuel strainer in a summer car?

The fuel strainer is a car part which can be found inside the garage at home. It is attached inside the engine bay with 1x8mm bolt. If you have trouble finding the placement, remember that the hose plugs into the side of the fuel pump. Use it as a guide.

How do you use a motor hoist in a summer car?

The hoist can be lowered by pressing RMB , and raised by pressing LMB . A clicking sound can be heard when the engine is at a suitable position and a bolt will appear at the end of both chains to be tightened. It can only be connected once the headers are attached to the block.

How do you adjust a carburetor on a summer car?

The fuel mixture can be adjusted by turning the screw on top of the carburator with a screwdriver; scrolling down makes the mixture richer and scrolling up makes the mixture leaner.

How do you adjust the timing on a summer car?

Aligning the camshaft of a fully assembled car is relatively simple:Unscrew the alternator and take off the alternator belt.Take off the crankshaft pulley (1x11mm)Take off the timing cover (6x6mm, the water pump and pulley can stay on)Take off the timing chain.Align the camshaft (1x10mm)Reverse the above steps.More items…